ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
PREPARING THE STAND
ASSEMBLING AND INSTALLING MATERIAL WORK SUPPORTS
Figure 5.
1. Lay the stand’s top surface down on the floor with the folded legs on top.
2. Press the Quick Release Leg Lock Lever and rotate that leg up until the locking pin clicks
into place.
3. Repeat with the remaining three legs.
4. Lift the stand and place it in an upright position.
5. Check to ensure the stand is stable and that all the legs have the locking pins engaged.
FIG 5
Figure 6.
1. Slide a carriage bolt (M6 x 55mm) through the square hole in the work support and extend
through the other side.
2. Place the work stop over the end of the bolt.
3. Thread a knob nut M6 (Part #12) over the end of the bolt and tighten to secure.
4. Slide the work support rail through the hole in the top of the work support mounting bracket.
5. Insert knob M8*25 (Part #11) through the small hole on the side of the material support
receiver and tighten to secure.
6. Slide the material support receiver over the extension rail so that the extension rail extends
through the opening in the receiver. Position the work support at the desired location on the
extension rail.
7. Thread knob M8*35 (Part #10) into the hole in the bottom of the material support receiver and
tighten to secure.
8. There are two M8*35 knobs. They have slightly longer shafts than knobs M8*25. To use, insert
them into the crossbeams to adjust the length of the extension rail.
9. Repeat with the other supports.
1. Unplug the saw and lock the saw arm in the down position.
2. Place a tool mount underneath the saw, aligning the mounting holes on the miter saw base
with the slot in the top of the tool mount.
3. Feed a carriage bolt up through both the tool mount and a mounting hole in the saw.
4. Secure in place using a flat washer, spring washer, and nut.
5. Repeat through the other end of the tool mount.
6. Place the second tool mount underneath the other side of the saw, aligning the mounting
holes on the miter saw base with the opening in the tool mount.
7. Install carriage bolts as previously described.
8. After making sure both tool mounts are parallel to each other, finger tighten all four nuts to
hold in position.
FIG 8
NOTE: If the saw has holes that do not line up with the slots in the tool mounts, use the
offset mounting brackets.
OFFSET MOUNTING
Figure 9.
Offset Mounting Bracket for Miter Saws and/or Power Tools with an irregular mounting hole pattern.
Instructions: Secure offset mounting brackets as shown using the supplied M8*60 Carriage Bolts
(Part #16). These brackets can be used on the front or rear of the Rapid Clamp Tool Mounts to
accommodate your specific power tool.
FIG 9
Page 9
Page 6
Offset Mounting Brackets
