ASSEMBLY INSTRUCTIONS
ASSEMBLY INSTRUCTIONS
ATTACHING THE PULL HANDLE
ATTACHING THE AXLE PLATE
Figure 3.
1. Extend the leg by depressing the leg lock levers.
1. Place (2) M8*20 bolts through the holes in the axle plate.
2. Place the axle plate onto the end of the Miter Saw Station making sure that the bolt runs
through the holes on the Miter Saw Station.
3. Place the washer and spring washer over each bolt on the back side of the Miter Saw Station.
4. Lift the Miter Saw Station to an upright position.
5. Tighten M8 nut over the washer until secure.
Washer
Spring Washer
Nut
FIG 3
FIG 4
Figure 4.
1. Place (2) M8*25 bolts through the holes in the plastic handle.
2. Place the handle onto the end of the Miter Saw Station, and make sure the M8 bolts pass
through the holes in the body.
3. Place a washer and spring washer over each bolt exposed on the backside of the Miter Saw Station.
4. Lift the stand and place it in an upright position.
5. Tighten M8 nut over the washers until secure.
Spring Washer
Washer
Knob Nut M6
Bolt M8*25
Knob M8*25
Knob M8*35
MOUNTING THE MITER SAW TO THE STAND
FIG 10
J-Clip
Leg Lock
Lever
Figure 10.
Use the handles located at the rear of the tool mounts to aid in installing or removing saw and
tool mount assembly.
1. Lift the saw and tool mount assembly, allowing the assembly to tilt slightly toward your body.
2. While still tilted toward you, hook the front edge of the tool mount assembly onto the front
rail of the stand.
3. Lower the tool mount assembly to allow the rear edge of the tool mount to seat fully over
the rear rail.
4. Lock the tool mounts in position by lowering the locking levers.
5. Snap the J-Lock
™
closed (around the beams) to prevent your mounted tool from detaching
from the MASTERFORCE
®
Miter Saw Station.
6. Check position and adjust if necessary to make sure the weight of the saw is evenly
balanced over the rails.
7. Ensure the saw is seated and locked in position, then securely tighten the four nuts holding
the saw to the tool mounts.
NOTE: Continue to hold the tool mount assembly with one hand until both levers are
securely locked.
Page 5
Page 10
