Page 11
REMOVING MOTOR FROM THE
FIXED BASE (FIG. 4)
1. Disconnect the plug from the power
supply.
2. Place the router on a flat surface.
3. With the back of the router facing you,
open the router motor clamp.
4. Push in the coarse-adjustment button
while you lift the router motor out of the
fixed base.
5. Set the motor upside down on its top
cap with the collet pointing up and
remove the cutter bit.
INSTALLING THE DUST-EXTRAC-
TION ADAPTOR (FIG. 5)
0
3/64
1/64
FIG. 5
Dust-extraction
adaptor
Fixed
base
To attach the dust-extraction adaptor onto
the fixed base, insert the dust-extraction
adaptor into the adaptor slot on the back of
the fixed base. Rotate the adaptor until it is
secured on the base; as shown in fig. 5.
OPERATION
ADJUSTING THE DEPTH OF CUT
WARNING:
Your router should
never be turned on or be connected to the
power source when you are assembling
parts, making adjustments, installing or
removing collets and cutter bits, cleaning
or when it is not in use. Disconnecting
the router will prevent accidental starting,
which could cause serious personal injury.
ASSEMBLY
DEPTH ADJUSTMENT WITH
FIXED BASE (FIG. 6)
0
3/
FIG. 6
Fine-adjustment
dial
Depth-indicator
ring
NOTICE: All depth adjustments on the
fixed base must be made with the motor
clamp open.
NOTICE: For fixed base routers, the cutter bit
depth equals the amount of the cutter that is
exposed below the surface of the sub-base.