Page 33
OPERATION
DUST COLLECTION
Your table saw is equipped with a dust
extraction port . For best results, connect a
vacuum to the port at the rear of the saw .
If the saw is operated without a vacuum
attached, some of the dust will be blown
out the dust collection port . After extended
use, the saw’s dust collection system may
become clogged .
MOVING THE TAbLE SAW
(FIG. 48)
before moving the
table saw with the stand, make sure the
saw is securely fastened to the stand with
the bolts, nuts and washers. Please see
“MOUNTING THE SAW TO THE TAbLE” in
this Operator’s Manual. Failure to do so
may result in serious personal injury.
1 . Hold the handlebar (with overmold), and
lift the handle end of the stand .
2 . Move the stand carefully to the desired
location, and put it down gently until the
two adjustable foot contact the ground .
FIG. 48
WARNING:
STORING THE TAbLE SAW ON
THE FOLDED STAND (FIG. 49)
You can fold the stand when the table saw
is not use . Please see “CLOSE THE STAND” .
Lift the stand to make the table saw with
stand straight up, as shown in Fig . 49, and
then store them in a free area .
FIG. 49
Summary of Contents for 15A Jobsite Table Saw
Page 38: ...Page 37 notes...
Page 40: ...Page 40 10 2011 2011 Menard Inc Eau Claire WI 54703...