Masterflex
MASTERFLEX
®
Gear Pump Drive Operating Manual
2-1
Section 2
Installation and Setup
Setup and Drive
Operation
Unpack the Pump Drive and retain all packing material until proper product
operation has been verified.
The Pump Drive rests on five vibration isolator feet for placement on a bench, desk
or table. It is supplied with a power cord.
1. If applicable, attach the Micropump Pump Head.
2. Check that the
0/l
Switch is in the
0
(off) position.
3. Connect the AC power cord on the rear panel to the AC power source.
4. Set the speed control to minimum.
5. Install the pump below the level of the supply liquid. the liquid must be
under atmospheric conditions.
6. This completes the basic setup.
C
D
A
Figure 2-1.
View of Rear Drive
A. IEC Power Entery Module
B. Power Switch
C. External Start/Stop Connector
