16
VIII. Assembly and adjustments (continued)
WARNING:
●
Only use a 12
’’
(30.5 cm) diameter blade.
●
To avoid injury from an accidental start, make sure the switch is in the OFF
position and plug is not connected to the power source.
!
INSTALLING THE SAFETY HOLD-DOWN
CLAMP (FIG. 6)
1. Place the hold-down clamp assembly
(1) in one of the mounting holes (2) as
shown.
Fig. 6
1. Open the battery cover (1).
2. Insert the two supplied AAA batteries
in the case as per the diagram below.
If replacing the batteries, take out the
old batteries and place with new AAA
batteries. Dispose of old batteries
properly.
3. Close the battery cover (1).
NOTE
: Replace the batteries with batteries
that have a rating of 1.5 V (Number 4
series and AAA size or equivalent).
1
2
2
INSERTING AND REPLACING THE LASER BATTERIES (FIG. 7)
• Unplug your mitre saw.
WARNING:
Failure to unplug your tool could result in accidental starting and cause possible
serious personal injury.
!
Fig. 7
AAA Battery
AAA Battery
1
2
2
Summary of Contents for Maximum Hawkeye Laser 055-6746-0
Page 46: ...46 Notes ...
Page 47: ...47 Notes ...
Page 48: ...48 Notes Imported by Mastercraft Canada Toronto Canada M4S 2B8 ...
