31
CUTTING USING THE GUIDE TRACK
– cont’d
6. Place one small clamp on the left
hand side of the guide track at each
end to hold it firmly onto the workpiece
with the
right edge
on the guide track
alignment marks.
7. Set the saw cutting depth (Fig. 7).
NOTE:
Make sure you support both the
“good” and “cut-off” sections of the
workpiece to prevent binding and kickback
as the saw cut is completed.
8. Place the runner of the track rider (7)
into the matching groove in the guide
track (8) (Fig. 28).
9. Slide the saw back until only 1"
(25.4 mm) of the front of the sole plate
is resting on the workpiece.
NOTE:
Make sure the blade does NOT
contact the workpiece.
10. Turn the saw ON and slide the saw
and the track rider into the workpiece
and complete the cut (Fig. 29).
INSTALLING ZERO CLEARANCE
INSERTS
This easy saw includes three zero
clearance inserts. These inserts will help to
prevent raised wood grain on the top side
of the cut. Each insert requires a slot to be
cut. The most common slots are 90°, 30°
and 45°.
ASSEMBLY AND OPERATING
Fig. 28
Fig. 29
Summary of Contents for 054-8326-0
Page 14: ...14 CONTENTS...
Page 15: ...15 CONTENTS...
Page 35: ...35 EXPLODED VIEW...
Page 36: ...36 EXPLODED VIEW GUIDE TRACK...
