10
EN
5/ DETERGENT PRODUCTS AND ADJUSTING THE WATER SOFTENER
Important:
It is very important to set the water softener correctly.
- If the setting is too low, there is the risk of chalky marks appearing.
- if the setting is too high, there is the risk of causing clouding of the glasses.
If you relocate, adjust the water softener setting as required.
• Traditional tablets
Non-multipurpose tablets should be placed in the external compartment (Fig 04) or, for optimum
performance, pull out the dispenser drawer and lay the tablet inside (Fig 05).
• Powders or liquids (Fig 03)
Fill at least up to the minimum mark for slightly dirty crockery and to the maximum mark for dirty
crockery. If the crockery is very dirty and for programmes with a pre-wash we recommend that you
add 5g of detergent (a dessert spoonful) into your dishwasher’s tub in accordance with the pro-
grammes table.
Important:
Keep these products out of children’s reach and away from dampness.
Only use products specially designed for dishwashers.
Fig. 04
Fig. 05
Fig. 03
• FOR TRADITIONAL PRODUCTS
• Your machine must be specially adjusted to use traditional products.
Set
Set
Set
Delayed
start
Remaining
Time
• Proceed as follows to set the water softener on the control panel:
— Turn the selector to the “
Opcje
” position. The screen now dis-
plays SEL to indicate that you are in the setting mode.
— Press the
“opóźniony start”
button
. The screen now displays
the setting (factory setting of
H4
).
— To change this setting (according to the hardness of the water)
continue to press the
“opóźniony start”
button. The setting chan-
ges every time you press the button. Consult the table below.
— The setting is automatically validated when you exit “
Opcje
”, namely, when the selector is in the
programme or Stop position.
Testing strip
Hardness
0-10°F
10-18°F
18-25°F
25-40°F
40-55°F
55-70°F
> 70°F
0-1mmol/l 1-1.8 mmol/l 1.8-2.5 mmol/l 2.5-4 mmol/l 4-5.5 mmol/l 5.5-7 mmol/l > 7 mmol/l
Traditional
product
HI
H0
H2
H3
H4
H5
H6
