14
Note:
The polishing accessory begins to move with
short, low-power impulses. The angle polisher thus
signals the actuation of the first switchpad.
Briefly
press the push button
3
on the gear
head.
The angle polisher starts gently and reaches its
lowest speed after a short time.
Notes:
The angle polisher does not start:
– when switchpad
4
/
6
and push button
3
are
pressed at the same time
– if one or more of the pressing surfaces is/are
pressed while the mains plug is inserted
Setting the speed
The speed can be controlled infinitely variable while
the angle polisher is running.
To increase the speed:
– Briefly press the switchpad
4
.
Reducing the speed:
– Briefly press the switchpad
6
.
The speed set is shown by the symbols on the speed
display
5
:
Note:
The power tool starts with the lowest speed at
each starting procedure.
The
self-start prevention lock
prevents the angle
polisher from starting again on its own accord if the
current supply has been interrupted during opera-
tion, e. g. by pulling out the mains plug.
Conduct the mains lead away from the rotat-
ing polishing accessory.
If you lose control
over the power tool, the mains lead could be cut
through or caught, thereby drawing your hand or
your arm into the rotating polishing accessory.
Polishing
Press the power tool on evenly and move it
over the surface.
Do not strain the power tool!
Do not allow the surface of the workpiece to
become too hot.
Stopping
Press push button
3
. The polishing accessory starts to
run down.
Maintenance and Cleaning
❏
Before any work on the machine itself, pull the
mains plug.
Carry out the following steps once a week, or more
often if used frequently:
Clean the cooling air vents.
Use non-metallic tools to clean the air vents.
Blow out the interior of the power tool from
outside through the air vents with dry, com-
pressed air.
Repairs may only be carried out by qualified
electricians in conformity with the valid regula-
tions.
Please always hand this Instruction Manual to
the those carrying out the repair.
If the supply cord of this power tool is dam-
aged it must be replaced by a specially pre-
pared cord available through the Würth customer
service centre.
If the machine should fail despite the care taken in
manufacturing and testing, repair should be carried
out by a Würth Master-Service agent.
For all correspondence and spare parts orders,
always include the article number on the type plate
of the machine.
For the current spare parts list of this machine, log
into the Internet under “http://www.wuerth.com/
partsmanager” or ask for a copy at your nearest
Würth branch office.
Disposal
Power tools, accessories and packaging should be
sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into
household waste!
According to the European Directive
2002/96/EC on waste electrical
and electronic equipment and its
incorporation into national law,
power tools that are no longer suitable for use must
be separately collected and sent for recovery in an
environmental-friendly manner.
200/min
350/500
/rpm
650/900
/rpm
1 000/
1200/rpm
1 500/rpm
➋
PM 250-E - .book Seite 14 Freitag, 22. September 2006 8:57 08
