www.masterproducts.es
22
Before carrying out any maintenance action on the machine, it must be disconnected from the electricity supply.
The machine must be switched off and disconnected from the electricity supply in case of an abnormal operation.
6. Disclaimers
Modifications to Master Products machines are prohibited without manufacturer approval. Following unauthorized
modification, the manufacturer declines any responsibility and cancels the warranty rights for the machines to which
modifications have been made. The manufacturer will not be responsible for any failures and accidents that may result.
During the warranty period, Master Products machines must only be disassembled and repaired by the manufactu
-
rer’s technical staff or official representatives.
7. Transport
Box 215 x 66 x 79 cm = 144 kg // Net weight of equipment = 61 kg
8. Electrical connection
The electrical connection must be carried out using a single-phase 230 V and 50-60 Hz power supply.
9. Placement
The Lift conveyor must be placed on a flat surface, without irregularities on the ground, ensuring stability and a good
working position. It is only suitable for indoor use and under no circumstances should the electrical part be exposed
to water.
Its design gives it the necessary stability and all four wheels have brakes to prevent unintentional movement.
10. Start-up
10.1. Assembly
The lift conveyor is delivered completely protected and fitted. To begin assembly, it is necessary to open the box
and check that all the material received is in perfect conditions and that the quantities are as detailed in this ma
-
nual. If this is not the case, contact Master Products Inoxidable, S.L. technical service or your distributor.
To facilitate the start-up of the equipment, it is recommended to place all the components supplied on a flat surface
and carry out all the steps detailed below.