Master F22, User Manual

Page: 47 / 77

EN
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This Can be
purchased from your local sports Retailer or a local hardware store.
4.5 Belt Adjustment
Belt Tension Adjustment
-It is very important for joggers and runners in order to provide a
smooth, steady running surface. Adjustment must be made from the right and left rear roller in
order to adjust tension with the Hexagonal Wrench provided in the parts package. The adjustment
bolt is located at the end of the rails as noted in diagram below:
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and
left bolt clockwise reasonably and inspect for proper tension. When an adjustment is made to the
belt tension, you must also make a tracking adjustment to compensate for the change in belt
tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure
.
4.6 Belt Tracking Adjustment
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for some
belts to drift near one side while the belt is running with no one on it. After a few minutes of
use, the belt should have a tendency to centre itself. If during use, the belt continues to move
toward one side, adjustments are necessary. The procedures are as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using
Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt and
Left bolt
Right bolt