en
it
de
es
fr
nl
pt
da
fi
no
sv
pl
ru
cs
hu
sl
tr
hr
lt
lv
et
ro
sk
bg
uk
bs
el
zh
amount extracted should be less
than 85% of the air intake. Forced
ventilation can be combined with
natural ventilation.
►1.11. Power the cooler solely
with the voltage and frequency
specified on the nameplate, using
cables of suitable section (the
supply voltage must not vary more
than ± 5% from the value stated on
the nameplate).
►1.12. Make sure the cooler is
earthed properly.
►1.13. Make sure the polarities are
respected when connecting to the
mains. We recommend using a 2P
10A residual current device.
►1.14. The cooler can withstand
a maximum water inlet pressure
of 3 Bar. If the pressure of the
water supply is higher, a pressure
reducer must be installed.
►1.15. Only fill the cooler tank only
with clean water.
►1.16. We recommend using
horizontal coverage to protect from
weathering, in order to preserve
the cooler over time.
►1.17. It is forbidden to alter, tamper
with or adjust the cooler and the
electricity or water supply after
installation, if it is not carried out
by qualified personnel.
►1.18. Do not obstruct, even
partially, the air vents of the cooler,
in order to prevent a hazard.
►1.19. In order to prevent serious
damage, do not let dust, dirt or
other materials come into contact
with the cooler.
►1.20. We recommend using the
cooler with ambient temperatures
between 18°C and 45°C and with
water temperature below 45°C.
►1.21. In order to prevent
serious breakdowns, when the
temperatures drop to about <2°C,
completely empty the tank and
the pipes that supply water to the
cooler.
►1.22. Disconnect the power supply
when you handle or service the
cooler (use personal protective
equipment in order to prevent any
hazards).
►1.23. If the power supply cable is
damaged, it must be replaced by a
technical support centre to prevent
any risk.
►1.24. Protect the power cable
from potential damage caused
by the movement of vehicles,
pedestrians, weathering and heat
sources.
►1.25. If the cooler malfunctions,
contact the technical support
centre.
►►2. UNPACKING
(Pic. 1)
IMPORTANT: IT IS STRICTLY
FORBIDDEN TO STACK TWO OR
MORE APPLIANCES.
►
2.1. Remove all packaging material
used to pack and deliver the cooler
and dispose of it in compliance with
current standards.
►
2.2. Remove all items from the
packaging.
►
2.3. Check for any damage incurred
during transport. If the cooler appears
damaged, immediately inform the
dealer from whom it was purchased.
►►3. ASSEMBLY AND
INSTALLATION (ONLY FOR
QUALIFIED PERSONNEL)
NOTE: TO ACCESS THE INTERNAL
PARTS OF THE COOLER, REMOVE
THE SCREWS AND EVAPORATION
