TWILIGHT SPA – CONTROLS
TS 6.2 • TS 7.2 • TS 8.2 • TS 8.3
32
INITIAL START-UP
When your spa is first actuated, it will go into Priming mode, indicated by
“
” Be sure the pumps and heating system are free of air by cycling the
pumps on and off with the spa-side panel buttons. The spa will not heat during
priming mode, allowing time to verify all air is purged from the heater. The
Priming mode will last for less than 5 minutes (press “Warm” or “Cool” to skip
Priming Mode) and then the spa will begin to heat and maintain the water
temperature in the Standard mode.
Warm/Cool (80°F - 104°F / 26°C - 40°C)
The start-up temperature is set at 100F°/37°C. The last measured temperature is
constantly displayed on the LCD.
Note that the last measured spa temperature displayed is current only when the
low speed of pump 1 has been running for at least 2 minutes (temperature is
always current on spas equipped with 24 hour circulation pump). To display
the set temperature, press the “Warm” or “Cool” pad once. To change the set
temperature, press the pad a second time before the LCD stops flashing. Each
press of the “Warm” or “Cool” pad will continue to either raise or lower the
set temperature. After three seconds, the LCD will stop flashing and display
the current spa temperature.
Jets 1
Touch the “Jets” button once to turn pump 1 on or off, and to shift between
low and high speeds. If left running, the low speed of the pump will automati-
cally turn off after 4 hours, and the high speed will automatically turn off after
15 minutes.
Jets 2
Touch the second “Jets” button once to turn pump 2 on or off. If left running,
pump 2 will automatically turn off after 15 minutes. This pump has one speed.
Jets 3 (If so equipped)
Touch the second “Jets” button once to turn pump 2 on or off. If left running,
pump 3 will automatically turn off after 15 minutes This pump has one speed.
Master Spa Parts
Call Us Today : (920) 727 - 1700
Master Spa Parts - 1068 American Drive, Neenah, WI, 54956, USA
