Master-force 240-0066, Owner'S Manual

Page: 5 / 16

The drill press is designed to be safely assembled by at
least two people working together.
INSTALL COLUMN SUPPORT
Refer to Figure 2
• Place the base on the floor or a bench.
• Place column on the base.
• Align the holes and secure the column on the base with
4 long hex bolts and washers.
Figure 2
INSTALL THE TABLE
Refer to Figure 3 and 4
• Locate the retaining ring on the column.
• Loosen the set screw on the retaining ring and remove
both the racket and ring from the column.
• Locate the table assembly. Place the rack inside the
table assembly bracket. Engage the rack’s teeth with the
pinion gear on bracket.
• Slide table assembly over the column.
• Position the rack so its end sits inside the beveled
column flange.
• Replace the retaining ring over the column and secure
with set screw.
• Check to see the top of rack is secured inside the
beveled edge of retaining ring. And the table assembly
can rotate around the column smoothly. Adjust the
retaining ring if necessary.
• Align and attach the crank handle to the shaft on the
table assembly. Secure with screw.
• Thread and clamp tight the table locking handle to
secure the table assembly on the column.
Figure 3
Figure 4
INSTALL THE DRILL PRESS HEAD
Refer to Figure 5
• Position and slide the head over the column.
• Carefully rotate the head on the column so it is aligned
with the base.
• Secure the drill press head with two lock set screws,
using the hex wrench.
3
ASSEMBLY
WARNING
Column
Base
Hex Bolt
Table Assembly
Retaining Ring
Column
Base
Rack
Crank Handle
Locking Handle
Table Assembly
Bracket
Set Screw
Pinion Gear
Crank Handle
Table
Alignment Pin
Locking Bolt