Master-force 240-0066, Owner'S Manual

Page: 6 / 16

Figure 5
INSTALL HANDLES
Refer to Figure 6
• Locate the three thread holes on the hub of the head.
• Thread the handles into the holes of hub until tight.
Figure 6
INSTALL THE CHUCK
Refer to Figure 7
Clean the spindle taper and the tapered hole in the chuck
before assembly. Remove factory protective coating with
alcohol or household oven cleaner.
• Rotate the chuck sleeve counterclockwise and open the
jaws as wide as possible.
• Place chuck on the taper of spindle and gently tape the
chuck into position with a rubber hammer or a hammer
with wood block. Never use metal hammer directly.
Figure 7
MOUNT DRILL PRESS
Refer to Figure 8
• The machine must be installed in a well-lighted area
with correct power supply.
• The machine can be installed on either a workbench or
a tool stand by using bolts, lock washers, and hex nuts.
• The machine must be bolted to a firm and level surface.
• There must be enough clearance for the moving
workpiece during operation. There must be enough
room for safety operation of the machine.
Figure 8
POWER SOURCE
Do not connect to the power source until the machine is
completely assembled.
The machine is wired for 120 volts, 60 Hz alternating
current. Before connecting the machine to the power
source, make sure the switch is in the "OFF" position.
Running the unit on voltages which are not within range
may cause overheating and motor burn-out. Heavy loads
require that voltage at motor terminals be no less than the
voltage specified on nameplate.
4
ASSEMBLY
WARNING
WARNING
Head
Assembly
Set Screws
Hub
Feed
Handles
Mounting
Holes
Head Assembly
Arbor
Chuck
Scrap Wood
Mallet