Operation (continued)
e.
t
the blade prior to turning the
nd reduce blade breakage, do
ng the workpiece against the straight edge and
e. The blade will deflect;
10.
ove the trailing edge of the workpiece beyond the blade guard foot.
Turn the switch OFF.
antity
Rip or straight line cutting
(Fig. 24)
1.
Raise the blade guard foot (1) by loosening the height
adjustment knob (2).
e desired distance.
240-0041
(888)315-3080
20
2.
Measure from the tip of the blade to th
Position the straight edge parallel to the blade at that distanc
3.
Clamp the straight edge to the table.
4.
Recheck your measurements using the workpiece to be cut
and make sure the straight edge is secure.
5.
Position the workpiece against the blade and place the blade
guard foot against the top surface of the workpiece.
6.
Secure the blade guard foot in place by tightening the heigh
adjustment knob.
.
Remove the workpiece from
7
scroll saw ON.
AUTION:
In order to avoid uncontrollable lifting of the workpiece a
C
not turn the switch on while the workpiece is against the blade.
8.
Position the workpiece against the straight edge prior to touching the leading edge of the
workpiece against the blade.
.
Slowly feed the workpiece into the blade, guidi
9
pressing the workpiece down against the table.
AUTION:
Do not force the leading edge of the workpiece into the blad
C
reducing accuracy of cut, and may break.
When the cut is complete, m
Tool needed
Qu
Description
2 Small
C-clamp
1
Ruler or measuring tape
1
12” straight scrap of wood
(thickness to match workpiece)
