3. Explanation of Control and Indicators
3.1 Product Illustration
① LCD
② “HOLD” Push Button
③ “FUNC” Push Button
④ Pin Holder
⑤
Test Pin (Gold-plated)（
‘INPUT’ Terminal）
⑥
Test Pin (Gold-plated)（
‘COM’ Terminal）
⑦
Battery cover
3.2. Push Buttons
[1] “FUNC
“
：
it is the function select key that acts trigger.
Use the Push Button as switch of Resistanc/Capacitance/Diode/Continuity.
The Tester is have not Power Key. When install the 3V Lithium Battery,
the Tester immediately power ON.
Once powered on, the Tester will perform the Scanning Mode and then
the
‘SCAN
’ and ‘
- - - -
’ sign is displayed on the LCD. This is indicate the
Tester is inter to the auto scanning mode and will be automatically identify
the resistor, capacitor, diode and continuity measurement mode.
The ‘FUNC’
Button is used to selecting some one measurement
mode manually.
[2] “HOLD” :
Press “HOLD” Button to enter or exit the hold mode
In any measurement mode. This key is act with trigger.
In the data hold mode, the Tester stop updating LCD, stored
current measuring data and displayed the measured data, and then
holding the data until press the “HOLD” key once again.
Note: after auto power-OFF is active, pushing any of the push
button can turn on the Tester again.
