Method of Usage
•
Install the joint ring and crossed screw on the round hole, which is at the right rear end of
the seat, and make sure to tighten it. (Figure 3)
•
Aligning the zip on the bottom of the back cushion and back-end of the seat cushion, zip
them up and pull down the bottom of the back cushion until it is smooth. (Figure 4)
•
Adjust the upper arms, then finish the installation of the seat cushion and upper arms.
(Figure 5)
5.
Armrest installation instructions
•
Find the air tube fitting and the corresponding plug connector from the bottom of the seat
frame and armrest then push it through the square hole on the fixed iron plate. (Figure 1)
•
After the plug connector gets through the square hole on the fixed iron plate, align it to the
corresponding connection plug. (Figure 2)
Method of Usage
•
Take the butt joint out from the bottom of the seat frame and plug it into the connector on
the armrest, and plug the air tube fitting. Make sure to it in plug well too. (Figure 3)
•
After connecting the plug, put it in the bottom of the seat frame through the square hole on
the fixed iron plate. Avoid folding the air tube.
•
Make the male pin on the armrest correspond to the female pin on the fixed plate, and the
outline of the iron plate correspond to the concave outline of the armrest. (Figure 5)
•
Hold the armrest and align the two male pins on the armrest to the female pin on the iron
plate (observe whether the connecting line is in the bottom of the seat frame to avoid it
getting stuck). The whole armrest should be hitched on the fixed iron plate.
•
After the armrest is hitched on the fixed iron plate, press the armrest downward. Make the
male pin on the armrest hangs over the female pin on the fixed iron plate, then pull the
armrest slightly to check that they are all fastened securely.
•
Find the mounting hole in front of the fixed iron plate, and screw the inner hexagon screw
and flat washer to the inner hexagon mount. (Figure 8)
12
13
