Masport Fatso Installing And Operating Instructions Download Page 11

REFUELLING (See FUEL, above)

We  recommend  that  the  top  door,  rather  than  the  hot-plate  opening,  be  used  for
refuelling.

CAUTION:  ALWAYS  ENSURE  THAT  THE  FLUE  DAMPER  IS  FULLY  OPEN  BEFORE

OPENING THE TOP DOOR OR LIFTING A HOT-PLATE.

(The damper  is open  when  its  handle  is in  line  with the  direction  of the  flue).  This will
prevent a possible flash-back from un-burned gases in the top chamber.

Using  excessive  quantities  of  green,  wet  timber  as  fuel  is  very  inefficient,  and  it  can
result  in  a  tar-like  deposit  of  creosote  or  soot  in  the  flue.  In  severe  cases,  these  can
restrict  flow  in  the  flue,  downgrading  the  stove’s  performance.  Occasionally  such
deposits can ignite, causing a flue fire. Should this occur, immediately close down all air
supplies to the fire, close the flue damper, and call the fire service. Flue fires are rare, but
if you have one you should have the flue inspected before using it again.

SAFETY

WARNING: ALWAYS KEEP CHILDREN AND INFIRM ELDERLY PEOPLE SAFELY

AWAY  FROM  THE  STOVE  WHEN  IT  IS  ALIGHT  AS  ALL  SURFACES  CAN
BECOME EXTREMELY HOT.

If such people might accidentally come into  contact  with  the stove, we  recommend the
installation of a safety guard.

Do not put furniture, clothing, firewood or other combustibles near the stove while it is
alight. A safe distance is 1250mm from the stove.

Do not run the stove with any of the access doors open. Keep hot-plates in place on the
stove unless the openings are covered by saucepans.

If you have had a flue fire, inspect the flue for damage before using the stove again.

Do not modify the stove or flue in any way without obtaining written approval from the
Manufacturer.

CAUTION:  THIS  APPLIANCE  SHOULD  NOT  BE  OPERATED  IF  ANY  PARTS  ARE

BROKEN OR MISSING.

MAINTENANCE

Cleaning  and  maintenance  should  always  be  carried  out  when  the  stove  is  completely
cold.

To remove the ashes, rotate the handle of the tipping grate smartly to tip them into the
ash  box. Lift  the ash door off  using  the  multi-purpose  handle and  remove  the  ash  box.
When disposing  of the ashes, remember they may still contain  hot  embers,  so  do  NOT
wrap  them  in  paper.  Place  the  removed  ashes  in  a  non-combustible  container  with  a
tightly  fitting  lid,  and  move  the  container  outdoors  immediately  to  a  place  clear  of
combustible materials.

Some models have a fibreglass cord gasket on the ash door. If this is damaged and may
leak, replace it with a genuine Masport spare part.

Your tipping grate will eventually need replacing. The new one can be inserted into the
grate handle from inside the stove. No dismantling of the stove is necessary.

Wiping  the  outside  of  the  stove  with  a  damp  cloth  can  result  in  smearing.  We
recommend using only a dry cloth for dusting the stove. Eventually it may be necessary
to touch  up the exterior  finish.  Use  only a  special Very  High Temperature  black Stove
Paint  (available  from  your  Masport  Dealer).  We  do  not  recommend  the  use  of  stove
polishes.

The outside of the flue may be cleaned, if desired, with a household metal polish. Do not
use steel wool or harsh abrasives.

If the stove burns sluggishly or has a low heat output, first check that the fuel is properly
dry. (See above). If the problem persists, it is probable that the flue needs sweeping. In
any case, we recommend having the flue swept once a season.

10

Summary of Contents for Fatso













Reviews: