Mash TT40 Cafe Racer, User Manual

Page: 48 / 52

48
Ampoule clignotant avant et arrière :
Remove screws and remove optics.
Lightly press the bulb and turn it counter clockwise.
Install the new bulb by following
the steps in reverse order as follows.
screw glass bulb
Side stand
Shore up the main stand, the motorcycle in proper position. Check the whether
the spring have scratch problem or not, the connector is lubricating.
Bolts, nuts and fasteners
All the bolts, nuts and fasteners shall be screwed
up as per the maintenance period table.
And check all the cotter pins, safety gripping gears,
locks, etc.
Cleaning the motorcycle
To keep a good looking of the covers, please wash your motorcycle often.
The best way to clean your motorcycle is to use warm water combining with
detergent to mop up the dirt before using water to clean up.
Warning
If you use high-press water to wash the motorcycle, please do not point the
squirt gun at the electrical parts, plug, cables, bearings and ECU, etc. The high
press would let the water get into the parts and lead to the failure of function
and premature aging.
-Please use ordinary brands to clean your motorcycle, for the dirtiest places,
please use brush to clean.
-Plug up the muffler before cleaning to prevent water getting into the inside
muffler.
-After cleaning with water, please mop up the motorcycle or just dry off. Ride for
a distance until the engine has reached a working temperature; meanwhile apply
brake to evaporate the water left inside the parts.
- Since the motorcycle cools down, please grease all the sliding parts and
bearings with lubricating oil, meanwhile grease the oil plug with lubricating oil.
- In order to avoid any sundries getting into the electronic system, please protect
your electronic system. When washing the motorcycle, please remove the air
cleaner cover and filter core and using foam or cotton yarn to protect the intake
channel. When washing, please block up the muffler to avoid the water getting
into the muffler and engine.