Maserati Ghibli, Owner'S Manual

Page: 91 / 308

3. Once the profile has been
recalled, press and release the
“S” button on the memory
switch, then press and release
button “1” or “2” accordingly.
“Memory Profile Set” 1 or 2 will
display in the instrument cluster.
4.
Press and release the button
on key fob RKE transmitter
within 10 seconds.
NOTE:
Your key fobs RKE transmitter can be
unlinked to your memory settings by
pressing the “S” button followed by
the
button on the key fob RKE
transmitter in Step 4 above.
Memory Position Recall
NOTE:
The vehicle must be in P (Park) to
recall memory positions. If a recall is
attempted when the vehicle is not in P
(Park), a message will display in the
instrument cluster.
To recall the memory settings for
driver, press MEMORY button number
“1” or “2” on the driver's door trim
panel or the
button on the RKE
transmitter linked to memory position
1 or 2.
A recall can be cancelled by pressing
any of the MEMORY buttons (“S”, “1”,
or “2”) during a recall. When a recall
is cancelled, the driver seat, external
side mirrors, adjustable pedals, and
power tilt and telescopic steering
column stop moving.
A delay of at least one second will
occur before selecting a new recall.
Easy ENTRY/EXIT Seat (optional
only for Driver Memory Seat)
This feature provides automatic driver
seat positioning to enhance driver
mobility when entering and exiting
the vehicle.
The distance the driver seat moves
depends on where you have the driver
seat positioned when you place the
ignition switch to the
OFF position.
• When you cycle the ignition to the
OFF position the driver seat:
• will move about 60 mm (2.36 in)
rearward if the driver seat position
is greater than or equal to ca.
68 mm (2.67 in) forward of the
rear stop;
• will move to a position of ca. 8 mm
(0.31 in) forward of the rear stop if
the driver seat position is between
23 mm (0.9 in) and 68 mm (2.67 in)
forward of the rear stop.
• The seat will return to its previously
set position when you place the
ignition into the
ACC or RUN
position.
• The Easy Entry/Easy Exit feature is
disabled when the driver seat
position is less than 23 mm (0.9 in)
forward of the rear stop. In this
position, there would be no benefit
to the driver by moving the seat for
Easy Exit or Easy Entry.
Each stored memory setting will have
an associated Easy Entry and Easy Exit
position.
NOTE:
The Easy Entry/Easy Exit feature can be
enabled or disabled using the MTC
System, refer to “MTC Settings” in
section 4 for further information.
Understanding the Vehicle
3
89