Z1 Free Ride
10/45
Warning
ASSEMBLING THE WHEEL ON FORKS
WITH QR20 PLUS DROPOUTS
A good and reliable operation of the fork
and all of the parts linked to it mainly
depend on the correct fixing of the front
wheel.
For a correct operation of the fork, install
the wheel as explained below:
· Unlock the locking device on both legs
pushing levers (
A
) downwards and opening
the small flap (
P
).
· For quick-release hubs, open the release
lever (
B
).
· For hubs with threaded cap, loose cap (
C
)
as much as needed to insert the wheel axle
through the wheel axle clamps.
· Insert the wheel axle (
D
) into the wheel
axle clamps.
· Check that the wheel axle supporting
bushes (
E
) are centred in the slider’s seat.
· If the wheel axle is equipped with a
quick-release system, lock the wheel with
the quick-release lever (
B
); otherwise, with
a 6mm Allen wrench, tighten the cap to the
side of the wheel axle to the recommended
tightening torque (see table - Tightening
torques).
· Verify the supporting bushes (
E
) stay
correctly.
· Check the correct fork-wheel alignment by
fully compressing the fork a few times.
the wheel a few times to verify the correct
alignment with the disk brake.
· Lock the locking device pulling levers (
A
)
upwards and adjust the clearance with the
adjusters (
H
), if necessary.
