Jr T
Q
R
2
0
FIG. F
Tighten the 4 stanchions fastening screws
(28) onto the crown to 11 Nm.
WARNING:
do not overtighten
the screws holding the stanchions
to the crown as this may distort the stan-
chion tubes and weaken the whole struc-
ture.
After any installation always check for the
following:
– proper torque of bolts fastening stan-
chion tube onto lower crown and up-
per plate;
– proper torque of bolts fastening brake
arch onto slider (11 Nm).
28
13
Nm
11
FIG. E
If the crown (34) position with respect to
the stanchion tubes (13) has been changed
for any reason, adjust the original dis-
tance.
– Distance “H” between crown and tyre
edge (when inflated) should not be
lower than total travel (130 mm) + 3
mm.
WARNING:
If steering crown is
improperly matched with stan-
chions, it may touch the tyre and cause
severe injuries to the rider.
H
