Remove the spring cup (
4
).
The old sealing rings and dust seals must not be used again.
Dismantling: Removing the guide bushes
Use the special extractor to remove the guide bushes. Do not use other tools.
Fit the aluminium bush (
A
) to the extractor keeping the side with larger diameter towards the edge
opposite to striker (
D
).
Fit the extraction washer (
B
) with a black finish to the extractor.
During use, remove the non-used washer from the extractor.
Remove first the top bushes, then the bottom bushes.
Fit the extraction washer keeping the blunt side towards the threaded grubscrew (
C
) fixed crosswise on to
the main rod as shown.
The slot in the rod lets the extraction washer swing inside the rod itself.
Insert the extractor in the arch-slider assembly from the side of washer (
B
) as shown.
The slot in the extractor rod will let the washer pass underneath the bush to be extracted.
Pull the extractor rod so that the upper face of the washer stops against the lower face of the guide bush.
Insert the aluminium bush (
A
) in the seat of the sealing ring.
While holding the main rod in position, the aluminium bush will drive the guide bushes during extraction.
Using striker (
D
) knock out and extract the guide bush (
1
).
Remove the guide bush (
1
) from the extractor.
Repeat the steps above to remove the bottom guide bush.
© Marzocchi Suspension
2006
-
Drop-Off SL
