Smear the dust seal and the sealing ring with some grease.
Insert the sealing ring (
3
) in its seat with the special introducer (
A
).
Using a hammer, knock in introducer (
A
) and drive the sealing ring home into the arch-slider assembly.
Using a small flat-tip screwdriver, fit the stop ring (
2
) and check that it fits perfectly into its groove.
Take great care not to damage the internal surfaces of the one-piece assembly when fitting
the stop ring.
The dust seals shall be refitted when reassembling the crown-stanchion unit / arch-slider assembly.
Assembling:
During the assembly of the pumping unit, strictly obey the instructions below.
Do not, at any times, reverse the position of the pumping elements in the fork legs (if you are unsure about anything, please refer
to the relevant exploded view).
Assembling: Assembling the pumping element
Insert spacer (
7
), the rebound spring (
4
), bush (
5
) and the bottom washer (
6
) in the piston rod (
3
).
Insert the pumping element into the stanchion.
© Marzocchi Suspension
2005
-
Dirt Jam Comp