MC8687P Mini PCIe WLAN Client Card User’s Guide
________________________________________________________________________
________________________________________________________________________
Doc. No________ Rev.V1.0
Confidential
Copyright © 2007 Marvell
Page
52
Document Classification: Proprietary Information
December 28, 2007
A Compliance
Statements
A.1 Federal
Communication
Commission (FCC) Compliance
A.1.1 Transmitter Module Approval Conditions
•
Antennas must be installed to provide 20 cm separation distance from the
transmitting antenna to the body of the user during normal operating condition. This
device must not be co-located or operating in conjunction with any other antenna or
transmitter.
•
Only those antennas filed under FCC ID: UAY-MC8687P can be used with this
device.
•
When the module is installed in the final system where the antenna location is less
than 20 cm separation distance to the body of user, additional equipment
authorization must be applied.
•
FCC ID label on the final system must be labeled with "Contains FCC ID: UAY-
MC8687P or "Contains transmitter module FCC ID: UAY- MC8687P ".
•
In the user guide, final system integrator must ensure that there is no instruction
provided in the user guide to install or remove the transmitter module.
•
The transmitter module must be installed and used in strict accordance with the
manufacturer's instructions as described in the user documentation that comes with
the product. This device complies with the following radio frequency and safety
standards.
•
The radio utilizes the following antennas:
1) PIFA antenna, with a maximum gain of 3.64 dBi.
A.1.2 USA-Federal Communication Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instructions, it may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
lf this equipment does cause harmful interference to radio or television reception, which
can be determined by tuning the equipment off and on, the user is encouraged to try and
correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the distance between the equipment and the receiver.
•
Connect the equipment to outlet on a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Modifications
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Caution:
Exposure to Radio Frequency Radiation
To comply with FCC RF exposure compliance requirements, a separation distance of
at least 20 cm must be maintained between the antenna of this device and all
persons. This device must not be co-located or operating in conjunction with any
other antenna or transmitter.
