Getting Started with the gplugD
Console Access
Copyright © 2010 Marvell
Doc. No. MV-S400320-00 Rev. -
December 2010
Page 17
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
If necessary, change the baud rate to 115200, data to 8 bit, and parity to none. Click “OK” to
apply the changes.
After the serial port is configured, start-up messages scroll by as Linux boots until the login prompt is
reached (see Figure 4).
Login as “root” with “nosoup4u” as the password. From this default shell, typical command line
programs are available. For example, dpkg –l | more lists the installed software packages.
U-Boot provides a short delay before loading the Linux kernel and launching the operating system.
From the shell, enter “reboot” to shutdown Linux and reset the chip.
7.
Press any key to halt OS loading when the U-Boot start-up message appears (Figure 5).
Figure 4: gplugD Login Prompt
Figure 5: U-Boot Start-Up
