42
MV01-94000-00
Rev C
Installing Anti-Tip Bars
1.
Disassemble (if necessary) Anti-tip Clamp and reassemble encompassing the rear
most tube on the Frame. Be sure to slide brackets as far outboard as possible before
lightly tightening.
2.
Insert Anti-tip assemblies into Clamps by depressing spring button.
3.
Rotate Anti-tip Clamp around Frame tube to achieve approximately 2” clearance
between the bottom of the Anti-tip bar wheel and the ground.
4.
Tighten bolts to 6Nm. WARNING: Use “Threadlocker Loctite 242” to lock threaded
fasteners against vibration loosening. Threadlocker Loctite 242 allows for fasteners to
be removed with hand tools. Failure to heed these warnings could cause damage to
your wheelchair, injury to yourself, a fall, a tip-over and/or loss of control, causing
severe injury to yourself or others.
MAINTENANCE
CAUTION:
Have a qualified wheelchair technician inspect your wheelchair every three
months.
CAUTION: You can expect your Marvel™ Wheelchair to give years of trouble free
performance if used properly. However a regular schedule of maintenance will make certain