5. Grasp the starter grip and slowly pull the starter cord out until you feel some resistance, then
pull the cord quickly and powerfully. Pull the starter grip until the engine starts. After the engine
is started, move the choke lever to the open position, then squeeze and release the throttle trig
ger to allow it to return to the idle position.
6. After starting, allow the engine to run a few minutes to warm it up before using.
NOTE:
1. Do not pull the starter cord out completely.
2. po not release the starter cord from the fully extended position.
3. Do notstart the engine without rear handle locked. (HT2321D-R, HT2321DL-R, HT2321DR
CA, HT2321 DLR-CA)
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" position.
This Hedge Trimmer is equipped with non-adjustable fuel mixture carburetor. The engine idle
speed is the only adjustment to the Operator.
The cutting blades may be moving during idle speed adjustment. Wear the recommended personal
protective equipment and observe all safety instructions.
Keep hands and body away from blade area.
Engine Idle Speed:
When the throttle trigger is released the engine should
return to an idle speed which is 2700-3300 rpm or just
below clutch engagement speed. The cutting blades
must not move and the engine should not stall (stop run
ning) at engine idle speed.
The engine idle speed is adjusted by rotating the idle
speed screw on the carburetor. Turning the idle speed
screw in (clockwise) increases engine speed while turn-
ing the screw out decreases engine speed.
If idle speed adjustment is necessary and after adjustment the cutting blades move or the
engine stalls, st«:llp using tlhe Hedge Trimmer immediately!
Contact your local authorized Maruyama Dealer for assistance and servicing.
-17-
