[Model:EHT2300D]
Tail
Socket Head Screw (2)
Spark Arrester
[Model:EHT2600D]
\\Y
'Socket Head Screw (5)
Spark Arrester
4.
Remove and clean the tail, gasket and spark
arrester with a safety solvent and a stiff brush. If
any part cannot be thoroughly cleaned, it must be
replaced.
S.
Reinstall the spark arrester, gasket and tail onto
the muffler, then reinstall and tighten the two
socket head screws.
6.
Reinstall the cylinder and air cleaner covers.
Exhaust Muffler
EHT2600D
Maintenance Interval
The muffler should be inspected and cleaned after each
I 00 hours of use.
Muffler Maintenance
I. With the engine at ambient (room) temperature,
loosen the knob and remove the air cleaner cover.
2.
Loosen the knob and lift off the cylinder cover.
3.
Remove the two socket head screws holding the
spark arrester assembly to the muffler and remove
the tail, gasket and spark arrester.
4.
Remove the three socket head screws holding the
muffler cover to the muffler body and remove the
muffler cover.
S.
Clean the muffler body and cover with a safety
solvent and a stiff brush.
IMPORTANT: Be careful not to allow any dirt
or debris to fall into the exhaust ports, as this
can cause engine damage.
6.
To reassemble the muffler cover to the muffler:
A. Apply liquid gasket (p/n 2619 IO) to the muf
fler cover sealing surfaces, then reinstall the
cover onto the muffler body.
B. Apply removable Loctite to the three socket
head muffler cover screws, then reinstall and
tighten the three screws.
7.
Reinstall the spark arrester, gasket and tail onto
the muffler, then reinstall and tighten the two
socket head screws.
8.
Reinstall the cylinder and air cleaner covers.
-20-
