— 17 —
2.
Move the choke lever to the closed ( ) position
and move the stop switch to the “ON” position.
3.
Lock the throttle trigger in the fast-idle start posi-
tion, then pull the starter grip.
4.
After the engine starts, move the choke lever to
the open (
) position, then squeeze and release
the throttle trigger to allow it to return to the idle
position.
If the engine stops running before you move the
choke lever to the open (
) position:
A. Go ahead and open the choke.
B. Make sure the throttle trigger is set to the fast-
idle start position.
C. Pull the starter grip until the engine starts.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1.
Pump the primer bulb at the bottom of the carbu-
retor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2.
Move the choke lever to the open (
) position
and move the stop switch to the “ON” position.
3.
Leave the throttle trigger in the idle position and
pull the starter grip.
4.
If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section above.
If the engine fails to start after you follow the
above procedures, contact an authorized
Maruyama dealer.
To Stop The Engine:
1.
Release the throttle trigger.
2.
Slide the stop switch to the “STOP” position.
Trimmer Operation
・
CAUTION
• Read the Safety instructions on page 6
concer ning proper use of the String
Trimmer.
CAUTION
• Don't disassemble recoil starter by your-
self. For ser vice, Please contact to
appointed dealer.
Starter Grip
Choke Lever
Stop Switch
STOP
START (ON)
Fast-idle lock
Throttle Trigger
(In fast-idle start
position)
Throttle Trigger
(In idle position)
➯
➯
