Assembly
Assembling Engine and Drlve
Shaft Assembly
The drive shaft, clutch drum housing and gearcase are
assembled. Attach the clutch drum housing to the
engine using the four M6 x 20 screws supplied with the
unit.
Engine
/
M6x20Screw(4)
Shatt
\
Clutch Drum Housing
Loop Handle Installation
The loop handle kit contains a package of four screws
and nuts, a rubber sleeve and the bottom clamp for the
loop handle.
Screw (4)
Rubber Sleeve
Bottom Clamp
1.
Slip the rubber sleeve around the shaft approxi
mately 9 inches (22.8 cm) from the encl of the stop
switch/throttle trigger assembly for an initial han
dle position.
2.
Rotate the rubber sleeve so the split is to one side.
3.
Place the loop handle and the bottom clamp over
the rubber sleeve.
4.
Install the four screws and nuts. Leave the screws
finger-tight.
5.
Reposition the loop handle up or down the. drive
shalt to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
6.
Tighten the screws and nuts.
-7-
