RUSH SM 650
TM
User Manual
13
Operation
Warning! Read ‘Safety information’ on page 4 before
operating the smoke machine.
The smoke produced by the
machine is hot enough to cause burns or eye injury if the safety
precautions are not followed.
Fill only with RUSH ELX
™
Smoke Fluid. Do not use water or any
other fluid. Doing so may be hazardous and will probably
damage the machine. Damage caused by use of other fluids is
not covered by product warranties.
Filling the tank
To fill the fluid tank:
1. Verify that the smoke machine is turned off.
2. Remove the filler cap.
3. Use a funnel to fill the tank to the fill line with approved smoke fluid. Pour in
less fluid if the machine is installed at an angle: to prevent leaks, fluid must
not come above the filler opening.
4. Replace the filler cap and verify that the feed hose touches the bottom of the
tank.
5. Wipe up any spills or drips.
Making smoke
1. Fill the fluid tank as described above.
2. Connect a remote control or wireless remote control receiver as described on
the previous page.
3. Connect the smoke machine to AC power and switch it on. Allow the machine
to heat up for several minutes. The machine is ready to use when the green
LED lights up on the wired remote control or the wireless remote receiver.
4. Verify that it is safe to fire the machine. Press the button on the remote control
until smoke is released. (Once the system has been primed, smoke will be
released instantly.)
5. Monitor fluid level and refill as necessary (after turning off the machine). The
“No Liquid” rear panel LED illuminates when fluid is exhausted and the pump
is automatically disabled.
6. When finished, turn off the machine and allow it to cool before handling. The
nozzle remains hot for three hours.
Summary of Contents for Rush SM 650
Page 1: ...SM 650 User Manual ...
Page 20: ......
