FAULT FINDING
This fault finding guide assumes that the system has already been
successfully installed and operational. If you have problems at the
installation stage, consult your local Martin agent for advice
No fog output when
using the remote control
to fire the heads
Heads are not ready
Fluid is below min level
Standby button is OFF
No fog output when
using DMX to fire the
heads
Incorrect DMX address
Heads are not ready
No DMX termination
Fluid level is below min
Add more fluid
Fluid out LED is lit on
the service module
Check settings
Allow time with DMX on
Fit 120 ohm resistor
Allow time to reheat
Add fluid
Set standby to ON
SYMPTOM
CAUSE
CURE
One or both heads is
not ready after 15
minutes heating time
Fog disperses too
quickly
Faulty control cable
Blown fuse in head
Check cable
Return to dealer to
repair fault
Wrong grade of fluid
used for the application
Choose a longer lasting
fluid (see front cover)
MAGNUM CLUB SMOKE SYSTEM
USER
GUIDE
8
SYSTEM LAYOUT GUIDELINES
Before beginning the installation, turn to page 4 of the user guide to see the
components that make up the complete system. This is the standard system,
expansions will be dealt with later in the guide.
For detailed instructions on installing each part of the system, refer to the
sections covering each module.
Start the installation by making a sketch of the site in order that cable and
fluid line runs can be optimized. Remember that you must allow for the
height of the heads as well as the distance across the floor space.
The maximum distances and heights can be found in the system
specification at the end of this guide.
When locating the heads, take account of any movement that may occur
when parts of the lighting rig move. This will require a loop of free cable and
pipe to be added into the installation. Avoid this type of installation if
possible.
Avoid locating the heads over public areas
Allow for maintenance access to all parts of the system to make fault finding
and system expansion easier.
Attempt to evaluate the way the effect will disperse in the venue before
permanently fixing the heads into position.
Route the fluid lines from the service module to the heads using smooth
bends to reduce the possibility of the pipe collapsing when forced into a tight
bend.
MAGNUM CLUB SMOKE SYSTEM
INSTALLATION
INSTRUCTIONS
9
