Control
settings
13
1.
Press the TIMER SET button. The ON light will flash. You are now
setting the On/Run time.
2.
Turn the knob to the required “run” time, as shown on the outer scale of
the knob (OFF – 255 seconds).
3.
Press the TIMER SET button once. The ON light will come on static and
the OFF light will flash. You are now setting the Off/Wait time.
4.
Turn the knob to the required “wait” time.
5.
Press the TIMER SET button once more. Both ON/OFF lights will come
on to show the timer is programmed.
The run and wait times are now stored and will be remembered even after the
unit has been switched off.
To start the timer using the times you’ve set, press the FOG / TIMER ENGAGE
button briefly. To turn off the timer, press the FOG / TIMER ENGAGE button
briefly again. When the timer is engaged, the ON light will come on during the
On/Run time and the OFF light will come on during the Off/Wait time.
If you only want to change the Off/Wait time, leaving the On/Run time
unchanged, press TIMER SET twice. This will take you directly to
setting the Off time without changing the On time.
To find out what the current time settings are, press TIMER SET then rotate the
knob slowly until the “ON” light begins to flash very rapidly. The knob is now set
to the current run/on time. Press TIMER SET once and rotate the knob slowly
again until the “OFF” light begins to flash very rapidly. The knob is now set to
the current wait/off time. Press TIMER SET again to get back to normal.
Setting the “one-shot” ti mer
The “one shot” timer allows you to pre-program the length of the haze burst.
This can be useful if you want to have a fixed-time burst of haze which you can
repeat at will by pressing the haze button.
1.
Press the TIMER SET button. The ON light will flash. You are now
setting the On/Run time.
2.
Turn the knob to the required “run” time, as shown on the outer scale of
the knob (OFF – 255 seconds).
3.
Press the TIMER SET button once. The ON light will come on and the
OFF light will flash.
4.
Turn the knob fully right to where “OS” (“One Shot”) is marked.
5.
Press the TIMER SET button once more.
The timer is now programmed to one-shot mode and this will be remembered
even after the unit has been switched off.
To produce a timed burst of haze, press the FOG button briefly. To stop the
timed haze output early, press the FOG button briefly again.
Summary of Contents for Magnum 2500Hz
Page 1: ...Magnum 2500HZ user manual P N 35010030D...
Page 25: ...Notes 25 Notes...
Page 26: ...26 Notes...
Page 27: ...27...
