60
Exterior 1200 Wash user manual
8 . 4 . 3 T o r q u e s e t t i n g s
The torque settings for the yoke screws as well as screws holding covers and part
numbers for the corresponding seals are as shown below.
To ensure that the Exterior 1200 Wash is waterproof and to avoid damaging threads, a
torque driver with a range from 2 Nm (1.5 ft.-lbs.) to 16 Nm (11.8 ft.-lbs.) must be used.
during service and adjustment.
Component
Torque setting
Seal P/N
A - Display cover
2 Nm (1.5 ft.-lbs.)
20620160
B - Rear cover
7 Nm (5.2 ft.-lbs.)
20620130
C - Connections box
2 Nm (1.5 ft.-lbs.)
20620150
D - Front cover
7 Nm (5.2 ft.-lbs.)
20620130
E - Front glass (screws inside luminaire)
2 Nm (1.5 ft.-lbs.)
20620140
F - Cooling fan housing
2 Nm (1.5 ft.-lbs.)
No seal fitted
G - Tilt lock
16 Nm (11.8 ft.-lbs.)
No seal fitted
H - Yoke slider
16 Nm (11.8 ft.-lbs.)
No seal fitted
Table 3: Torque settings and seal part numbers
A
B
C
D
D
E
E
F
F
G
H
Figure 17: Torque settings
Summary of Contents for Exterior 1200 Wash
