![background image](http://html1.mh-extra.com/html/martin/dt2s/dt2s_operators-manual_1732733020.webp)
Martin Engineering M3687-12/17
16
Martin
®
DT2S Reversing Cleaner
end stops. Slide the blades out of the cartridge and replace by sliding in
new blades. Ensure the blades face in the correct direction. Re-fit the end
stop. These prevent belt damage by supporting the belt at the edge of the
cleaning blades. If removing both end stops, first mark their position in
the cartridge to ensure correct positioning of blades on re-assembly.
4. Re-install blade cartridge onto the cleaner mainframe and re-fit the
securing pin at the operator side. Re-tension the cleaner.
5. Remove equipment from service if there is any indication it is not
functioning properly. Call Martin Engineering or representative for
assistance. Do NOT return equipment to operation until the cause of the
problem has been identified and corrected.
6. Wipe all labels clean. If labels are not readable, contact Martin
Engineering or representative for replacements.
WARNING
!
Failure to remove tools from maintenance area and conveyor
belt before turning on energy source can cause serious injury
to personnel and damage to belt.
7. Remove all tools from maintenance area.
DANGER
!
Do not touch or go near conveyor belt or conveyor accessories
when conveyor belt is running. Body or clothing can get
caught and pulled into conveyor belt, causing severe injury or
death.
8. Start conveyor belt.
9. Observe cleaner action and blade effectiveness.
Maintenance