Service manual
18 of 20
Atomic 3000 LED - Revision A, 11-30-2017
Figure 39: Read the user manual
Maintenance
Read the user manual before performing service or
maintenance on the product.
Failure to respect service and maintenance schedules
may cause damage that is not covered by product
warranties.
Cleaning the product
Cleaning schedules for lighting fixtures vary greatly
depending on the operating environment. It is therefore
impossible to specify precise cleaning intervals for the
fixture. Environmental factors that may result in a need
for frequent cleaning include:
•
Use of smoke or fog machines.
•
High airflow rates (near air conditioning vents, for
example).
•
Presence of cigarette smoke.
•
Airborne dust (from stage effects, building
structures and fittings or the natural environment
at outdoor events, for example).
If one or more of these factors is present, inspect
fixtures within their first 100 hours of operation to see
whether cleaning is necessary. Check again at frequent
intervals. This procedure will allow you to assess
cleaning requirements in your particular situation. If in
doubt, consult your Martin
®
by Harman dealer about a
suitable maintenance schedule.
Only clean on the outside.
Do not use concentrated alcohol solutions, abrasive
products or solvents to clean the lens. If wiping with
a soft, lint-free cloth dampened with distilled water
is not effective, dampen the cloth with distilled water
containing 20% isopropyl alcohol in solution.
Conditions
Procedures in the cells marked with red must be
carried out by certified Martin
®
by Harman technicians
only. Otherwise, you may cause damage to the product
that is not covered by your product warranty.
Ambient temperature:
Minimum: +5° C.
Maximum: +40° C (104° F).
Daily “lamp on” hours: 12 hours.
Voltage and frequency: 100-240 V, 50/60 Hz.
I
Inspect
R
Replace
C
Clean
L
Lubricate
A
Adjust
SC
Fan self-clean
U
Update
Martin
®
by Harman
Figure 40: Legend, maintenance schedule
