6
2.
Slide the handle shield in place from below. Align the
holes, and slide a handle shield bolt through each hole
from inside (Figs. 4 – 5).
3.
Align the handle shield knob with the bolt, then use your
hand to tight. Repeat for the remaining three bolts (Fig. 6).
NOTE:
Make sure all the bolts and knobs are secured.
Fitting the Handle
1.
Remove the cotter pins on the posts on both sides of the
mower body (Fig. 7).
2.
To assemble the handle assembly on the mower body,
insert the posts on both sides into the holes on the ends
of the lower handle bars (Fig. 8).
NOTE:
Some force may be needed to separate the handle
legs so they fit over the posts.
3.
Insert the cotter pins in the original slots on the posts on
both sides to secure the handle assembly (Fig. 9).
Handle shield
Fig. 4
Handle shield
Fig. 5
Handle shield bolt
Fig. 6
Handle shield knob
Handle shield bolt
Fig. 7
Post
Cotter pins
Fig. 8
Handle
assembly
Post
Lower handle bar
Fig. 9
Cotter pin
Post
Summary of Contents for MTS-MRM18
Page 12: ...snowjoe com ...
