E: [email protected] | P: 02 8778 7500
www.martecaustralia.com.au
WARNING
Installation MUST carry out by a qualified and licensed electrician.
How to Install Blades
NB: Ensure the blades do not get damaged or bent during the installation process while the fan maybe on the ground, this will affect the
performance and balance of the fan and this is NOT covered under warranty.
The screw installed on the upper housing must align at the gap as
shown. (See Fg.5)
Remove the screw at the lower housing. Align holes on the blades
with holes at the bottom of the motor. Tighten the blade using screws
provided. Repeat the same step until all blades are installed.
CCT (Colour Changeable Temperature)
Choose colour temperature by flicking the switch in the
LED (See Fg.10)
C = 5000K cool white
N = 4000K neutral white
W = 3000K warm white
Fg.8
Fg.5
How to Install / Remove the Cover
To install:
Remove the screw from the connecting plate. Plug
the wire into the light kit mounting hole. Align the thread with
connecting plate before tighten the screw.
To remove:
Turn anti-clockwise.
Fg.6
To install:
Align face plate with the blade gap
before pressing.
To remove:
Turn anti-clockwise.
Fg.7
Model shown with light
Model shown fan only
Decoration Cover
Connecting
Plate
LED
