5
Do not pull the cord. Always take the socket. Do not reel the cord around the device housing.
Never attempt to frame and repair the appliance by yourself. If you meet problems, please contact the nearest customer service center.
Using accessories or replacement parts that are not recommended or sold by the manufacturer may cause damage to the appliance.
Always unplug the appliance and let it cool down before cleaning and removing parts. Keep unplugged when not in use.
To avoid electric shock and fire, do not immerse in water or other liquids. If this occurs, immediately unplug it and contact service center for inspection.
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person responsible for their safety.
Be cautious when using blade.
Every time after use, make sure the appliance is turned off, the blades stopped completely. Only then open the lid.
Do not overload the appliance. The appliance is designed for processing relatively small quantities of food and maximum quantities given in the table should not be exceeded.
Never blend hot liquids!
Maximum time of continuous operation - no more than 1 minute with an interval for at least 5 minutes.
Do not use the device if the cord is damaged.
Do not use the device if the cup is empty.
Do not leave the device unattended.
Always disconnect the device from power supply if you do niot use it and before cleaning.
BEFORE THE FIRST USE
Please unpack your appliance and remove all packing materials
Clean the motor unit with dump cloth, wash blades and jar with soapy water, rinse and dry.
Do not immerse motor unit into water.
INSTRUCTION FOR USE
CHOPPING
Place the device on a flat steady surface.
Place the blade unit (4) on the drive spindle (5), position sealing ring (3) and put the jar (2) on, screwing it clockwise until fixed.
Load the ingredients into the jar.
Caution:
blender cannot be used for crushing ice and very hot ingredients with temperature more than
60
С°
. This can cause damage of the device.
Place the lid (1) on top of the the jar and tighten it turning clockwise.
Insert the plug into power supply.
Put the ingredients in the jar. Cut big pieces into smaller ones with size of 2-3 cm. Add liquid.
Speed modes: 1, 2 or pulse mode . To stop the blender press 0.
Start with lower speed and then increase it. Use pulse mode for short times if necessary.
Do not put more than 0.8l of hot liquids or foamy ingredients. Never exceed max level of the jar!
If ingredients are not mixed well or stuck, stop the blender and mix the ingredients with silicone spatula. It is recommended to mix sticky ingredients from time to time with the spatula.
Caution:
never put any items in the blender jar when blade is working!
Before opening lid wait until blade fully stops. Before removing jar from the motor unit unplug the device from the power source.
CAUTION:
For most kinds of food, it is advisable to switch on the device a few times in succession and then to continue operating until the required degree of fineness has been achieved.
Do not overload the appliance by putting in too much food and do not operate continuously for more than one minute. In pulse mode work time should not exceed 20 secs.
