Marshall Electronics V-MD171X, Operating Instructions Manual

Page: 3 / 22

3
Installation and Initial Setup
■
Unpacking
Carefully unpack the monitor and verify that the following items are included:
• MD-171 Monitor
• V-PS12-5V-XLR Power Supply with 4-Pin Male XLR Connector
• Operating Instructions
Inspect the unit for any physical damage that may have occurred during shipping. Should there be any damage,
immediately call Marshall Electronics Customer Service at (800) 800-6608. If you are not located within the continental
United States, call +1 (310) 333-0606.
■ Installation
The V-MD171X can be mounted in any standard EIA 19” equipment rack. The attached rack ears can be angled to
provide the user control over the viewing angle. Adequate ventilation is required when installed to prevent possible
damage to the monitor’s internal components.
A VESA standard 75mm hole pattern also allows custom mounting installations. Alternately, the V-MD171X can be
used in a desktop configuration with optional stand (Marshall part number V-ST15).
■
Input Slots
Install any optional input modules BEFORE applying power to unit. Please see detailed instructions on Page 9.
■ Connections and Power-On
Plug the V-PS12-5V-XLR power supply into an AC power source (100-240 V @ 50/60 Hz). Attach the 4-pin male twist-
lock connector to the back of the monitor. The monitor draws a maximum of 3.0 Amps at 12 Volts in operation.
Connect the required cables for video signals, tally, etc. (Power must be applied to the V-MD171X for any of the active
loop-through outputs to be activated.) All BNC connectors are rated at 75
Ω .
The unit defaults to ‘ON’ when power is supplied.
V-MD171X with optional desktop stand (Marshall
Part Number V-ST15)