Mars FLAVIA CREATION C500, User Manual

Page: 5 / 20

Brewer Dimensions and Weight:
Height – 17.1”(435mm) Width – 10.6”(266mm) Depth – 19.9”(506mm)
A gap of 3”(72mm) is required behind the Brewer if it is to be plumbed in.
Out of box Weight – 27.8lbs (12.6Kg)
Weight with water tanks filled – 33.3lbs (15.1Kg)
Electrical Supply:
It is important that you have a power supply ready so that we can install your new system
quickly and efficiently.
You will need to supply a suitably rated and protected (i.e. via RCD and/or MCB) incoming
supply. The machine must be connected to the supply via an earthed wall socket ideally
incorporating a switch.
Please refer to the rating label on the back of the machine for details of the supply voltage,
frequency and power rating required to operate the brewer.
Use only one system per socket and ensure it is earthed.
Your system is fitted or comes supplied with a mains lead that is a
minimum of 5’9” (1.75m) in length. Only this lead should be used,
no old leads should be re-used.
If you are connecting your appliance to the mains drinking water supply, the following requirements must be
met:
A brass stopcock to BS1010 standard with a 15mm compression outlet or a brass stopcock with 3/4 inch BSP
male outlet.
Water pressure must be between a maximum of 7 bar (100 psi) and a minimum of 1 bar (14.5 psi)
Flow rate of at least 8.45 oz/minute (250ml/minute).
Water to be cold drinking water and sodium free.
Install in accordance with local plumbing regulations.
Connect mains water to filter with 3/8 in. NPT male fitting.
Jointing compound should not be used in the water supply to the system as this will affect the drink
flavor, only use PTFE tape.
Do not locate the water supply above the mains power socket.
We draw your attention to the requirements of the Water Supply ( Water fittings) Regulations 1999
2
ENG
SAFETY AND INSTALLATION GUIDELINES
REGULATORY COMPLIANCE
This system has been designed and manufactured in compliance with the relevant regulatory
compliance requirements for your market
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
INSTALLATION OF YOUR CREATION® 500 BREWER
If you are unsure about
any installation
requirements, consult
an electrician and/or
a plumber.
●
Notice
•
•
•
•
•
•
PLUMBED SYSTEMS
•
•
•