Owner’s Manual -
Plastic Oscillating Desktop Fan
2
CAUTION
WARNING
INSTALLATION INSTRUCTIONS
Read Rules for Safe Operation and Instructions Carefully.
1. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of elec-
tric shock, this plug is intended to fit in a polarized outlet only one way. If plug does not fully fit in
the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to
defeat this safety feature.
2.
To reduce the risk of fire or electric shock, DO NOT use this fan with any solid-state speed control
devices.
RULES FOR SAFE OPERATION
1.
Never insert fingers, pencils, or any other object through the grille when fan is running.
2.
Disconnect fan when moving from one location to another.
3.
Disconnect fan when removing grilles for cleaning.
4. Be sure fan is on a stable surface when operating to avoid overturning.
5.
Do not use fan in window. Rain may create electrical hazard.
6.
Ensure that the fan is switched off from the supply mains before removing the grille.
The rules about cord and plug as below:
1.
This product employs overload protection (fuse). A blown fuse indicates an overload or short-
circuit situation. If the fuse blows, unplug the product from the outlet. Replace the fuse as per the
user servicing instructions (follow product marking for proper fuse rating) and check the products.
If the replacement fuse blows, a short-circuit may be present and the product should be discarded
or returned to an authorized service facility for examination and/or repair.
2.
Do not operate any fan with a damaged cord or plug. Discard fan or return to an authorized ser
-
vice facility for examination and/or repair.
3.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners, or similar coverings.
Do not route cord under furniture or appliances. Arrange cord away from traffic area and where it
will not be tripped over.
S
O
N
Name of components
Front grill
Motor
Rear grill
Plastic Nut
Tighten Plastic
Nut clockwise
and fixate the
Rear Guard.
Fan Blade
After installing
Fan Blade, turn
it with hand to
ensure normal
movement.
Fan Blade Nut
Tighten Fan Blade
Nut by turning it
counterclockwise.
Then install Front
Guard.
Button
Base cover
1. Place the Front Guard upright,
with the Positioning Clip aligned
with the Rear Guard as illustrated.
2. Press down all the Buckles to fasten
the Front Guard with the Rear Guard.
Front and Rear Guard Installation
Buckle