12
13
11
Exit the custom setting menu. Press Set button to return to main menu.
Setup Guide
1.
Turn the camera off
2. Press the Power button for more than 3 seconds to turn on the GPS receiver.
The “GPS” icon on the upper right of LCD screen will flash, indicating that it is
searching for satellites. When a steady satellite signal is captured, the “GPS”
icon will stop flash.
It takes about 60 seconds to start the receiver up when cold, 15 seconds if you
have just shut it down then restart, and 1 second to wake up the LCD screen.
For successful positioning, you must be outdoors with good weather and a sky
unobstructed by tall buildings.
3. Press the Menu button (page backward) or Power button (page forward)
to view the parameters displayed on the screen. If any parameters need to
be changed, select main menu “Set?” and press the Set button to enter
the submenu. Set parameters according to your needs and exit the submenu
(Refer to page 7 “LCD Display Operation Guide”) .
4. Select the correct camera connecting cable (N1 or N3) for your camera. The
MX-G20M MKII GPS receiver is compatible with Nikon DSLR cameras with a
GPS setup menu including but not limited to the following:
N1 (Ten-Pin) Cable: Nikon D2X, D2XS, D2HS, D3-series, D4, D4S, D200 D300-
series, D700,D800, D800E, D810, D810a
N3(Flat) Cable: Nikon Df, D90, D600, D610, D750, D3100, D3200, D3300, D5000,
D5100, D5200, D5300, D5500, D7000, D7100, D7200, COOLPIX P7800, P7700
For cameras with a ten-pin remote terminal on the front of their
bodies:
• Insert the end of the N1 USB cable into the data port of the MX-G20M
MKII. When inserting the cable, please be sure that the end is oriented
correctly and do not use force.
• The pins on the end of the N1 cable should line up with the holes of the
ten-pin remote terminal on the your camera’s body, please gently insert
the cable and tighten the locking nut.
For cameras with a rubber accessory terminal cover on the side of
their bodies:
• Insert the end of the N3 cable into the data port of the MX-G20M MKII.
When inserting, please be sure that the end is oriented correctly and do not
use force.
• Insert the end of the N3 cable into the accessory port under the terminal
cover on the side of the camera body. When inserting, please be sure
that the end of N3 is oriented correctly and do not use force.
