Fan Installation MQRB4436 / MQRB5143 / MQRB6961
FAN KIT IS FOR USE IN BK (SINGLE SIDED) INSTALLATIONS ONLY
Fan Kit should be installed before the fireplace is placed into wall cavity. To
remove
fan for service, the burner pan must
be removed and work done through the opening (See
Burner System Removal
section).
WARNING
Electrical Grounding
Instructions
This appliance is equipped with a
three prong (grounding) plug for
your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this.
Before Servicing
1. Ensure all power supply is
shut off.
2. Label all wires prior to
disconnecting when servicing
control. Wiring errors can
cause improper and
dangerous operation.
3. For fan servicing: Vacuum and
clean lint/dirt build-up on the
fan blades and motor.
4. When resealing the Burner
Pan, use
Millpac
.
NOTE:
If Fan Mount Tabs are not present, place fan as shown and mount with screws. Thermodisc must be
mounted under burner pan. If no place is provided, mount with a screw from the valve bracket.
!
NOTE: Do not allow any power
cords or wires to come into
contact with the firebox or the
underside of the burner pan.
Fan Speed Control
(Locate Outside of
Fireplace)
Thermodisc
(Located under
Burner pan)
51
