Millivolt System, Lighting, and Burner Control
WARNING
FOR YOUR SAFETY READ BEFORE LIGHTING
BEFORE LIGHTING
A
This appliance has a pilot which must be lighted by hand. When
lighting the pilot, follow these instructions exactly.
B
Smell all around the appliance area for gas. Be sure to smell
next to the floor because some gas is heavier than air and will
settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•
Do not try to light an appliance.
•
Do not touch any electrical switch; do not use any phone in your
building.
•
Immediately call your gas supplier from a neighbour’s phone. Follow
the gas supplier’s instructions.
•
If you cannot reach your gas supplier, call the fire department.
C
Use only your hand to push or turn the gas control knob. Never use
tools. If the knob will not push in or turn by hand, don’t try to repair it.
Call a qualified technician. Force or attempted repair may result in a
fire or explosion.
D
Do not use the appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system which has
been under water.
LIGHTING INSTRUCTIONS
1.
Stop! Read the safety information above this label.
2.
Set the thermostat (Thermostats are not permitted for vented
[Decorative] gas fireplaces installed in the U.S.A.) to lowest
setting.
3.
Turn off all electrical power to the appliance.
4.
Locate valve under the burner assembly.
5.
If the control knob is not already in the off position, i.e. the word
“OFF” in the 9 o’clock position, then push in the gas control knob
slightly and turn
clockwise to “OFF”. NOTE: Knob cannot be
turned from “PILOT” to “OFF” unless knob is pushed in slightly.
Do not use force.
6.
Wait five [5] minutes to clear out any gas. If you then smell gas.
STOP! Follow “B” in the safety information above on this label. If
you don’t smell gas then go to the next step.
7.
Now push in the control knob slightly and turn counter-
clockwise to the “PILOT” position.
8.
Push in the control knob all the way and hold it. With the other hand
push in the red ignitor button until you hear a click. Now observe
closely the pilot burner located on the rear center-left hand side of the
main burner. If a flame has appeared then continue to depress the
control knob for 20 seconds. If the flame did not appear then continue
to depress the red ignitor button every 5 seconds until a flame is
established. NOTE: If after 30 seconds a flame has not yet been
established then turn the control knob back to the off position and
repeat steps 5, 6 & 7.
9.
Once the pilot has been established hold the control knob in the
depressed position for approximately 25 seconds before releasing. If
the flame goes out then repeat steps 7 and 8.
10. Now turn the control knob to the “ON” position. The burner will not
light unless the wall switch thermostat (Thermostats are not permitted
for vented [Decorative] gas fireplaces installed in the U.S.A.) or
remote control is turned “ON” or in the case of the thermostat
(Thermostats are not permitted for vented [Decorative] gas fireplaces
installed in the U.S.A.) there is a call for heat.
11. Close the access door and turn all electrical power back to the
appliance.
TO TURN OFF THE APPLIANCE
1.
Set the thermostat (Thermostats are not permitted for vented
[Decorative] gas fireplaces installed in the U.S.A.) to lowest
setting.
2.
Turn off all electric power to the appliance if service is to be
performed.
3.
Open the control access door.
4.
Push in the gas control knob slightly and turn
clockwise to the
“OFF” position. Do not force.
5.
Replace control access panel.
Recommended Maximum Lead Length (Double
Wire) When Using Wall Switch or Thermostat
(Thermostats are not permitted for vented
[Decorative] gas fireplaces installed in the U.S.A.)
Wire Size
Max. Length
14ga 100ft
[30.4m]
16ga 64ft
[19.5m]
18ga 40ft
[12.1m]
20ga 25ft
[7.6m]
22ga 15ft
[4.5m]
CAUTION:
DO NOT WIRE 120V POWER TO
MILLIVOLT SWITCHES OR THERMOSTAT
(THERMOSTATS ARE NOT PERMITTED FOR
VENTED [DECORATIVE] GAS FIREPLACES
INSTALLED IN THE U.S.A.).
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
Always light the pilot whether for the first time or if the gas supply has ran out with the glass door opened or removed.
34
Summary of Contents for Cove MQZDV3927
Page 37: ...37 ...
