TEMPERATURE DISPLAY AND ADJUSTMENT
The LCD window displays the actual water temperature. Pressing the TEMP SET pad
will make the numbers flash, then pressing the pad again (repeatedly) will increase the
set temperature one degree at a time, up to 104° F. After a short pause, the actual
temperature will again be displayed. Repeating the above procedure will allow you to
decrease the set temperature.
HEAT LIGHT
The HEAT ON light will illuminate when the heater is on.
LCD DISPLAY MESSAGES
The advanced technology built into the spa allows it to perform a number of self-
diagnostic system checks and can display a variety of messages on the LCD panel. See
TROUBLESHOOTING section for descriptions.
MAINTENANCE REMINDERS
Maintenance Reminders help remind you of routine maintenance procedures.
CL:
This will appear every 30 days as a reminder to clean the filter.*
CH:
This will appear every 90 days as a reminder to drain and refill the spa.*
*NOTE:
If power is shut off or a power outage occurs the system has a battery
backup. Maintenance Reminders will be stored in memory for 30 days. If power does
not resume after that time, memory will reset to factory default settings and history lost.
ZONED THERAPY SYSTEM AUXILIARY PANELS
Pressing the ZONE 1 JETS pad will activate the Power Therapy Seat (see spa diagram
for exact location). The ZONE 1 JETS pad will cycle the jet pump from low-speed, to
high-speed, to off. This sequence will be followed beginning at whichever speed the
pump may be in when the pad is pressed. Pressing ZONE 2 JETS or ZONE 3 JETS pads
will activate the jets in the other areas of the spa. The Zone 2 and Zone 3 pumps
follow the same sequence as that of Zone 1.
Pump Timeouts
Zone 1:
Operating sequence is low speed and ozone generator, high speed, then off.
If left running, the low speed and the ozone generator turn off after 15 minutes. If left
running, the high speed runs for ten minutes then reverts to low speed for five
minutes before turning off.
Zone 2:
Operating sequence is low speed, high speed, then off. If left running, the
low speed will turn off after 15 minutes. If left running, the high speed runs for ten
minutes then reverts to low speed for five minutes before turning off.
Zone 3:
Operating sequence is low speed, high speed, then off. If left running, the
low speed will turn off after 15 minutes. If left running, the high speed runs for ten
minutes then reverts to low speed for five minutes before turning off.
M A R Q U I S S P A S • R E L A X I N G Y O U R W O R L D 5 5
U L T I M A T E S E R I E S C O N T R O L S
ZONE 1
JETS
ZONE
D THERAPY SYSTEM
ZONE 2
JETS
ZONE
D THERAPY SYSTEM
ZONE 3
JETS
ZONE
D THERAPY SYSTEM
