S A F E T Y I N S T R U C T I O N S
M A R Q U I S S P A S • R E L A X I N G Y O U R W O R L D 3
The following instructions are required to be printed by Underwriters Laboratories (UL) as
a condition of the listing of this product. They contain important safety information, and
we strongly encourage you to read and apply them.
IMPORTANT SAFETY
INSTRUCTIONS
WHEN INSTALLING AND USING THIS ELECTRICAL EQUIPMENT,
BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED,
INCLUDING THE FOLLOWING
:
1.
READ AND FOLLOW ALL
INSTRUCTIONS
2.
WARNING:
To reduce the risk of injury, do not permit children to use this product
unless closely supervised at all times.
3.
DANGER:
RISK OF CHILD DROWNING. Extreme caution must be exercised to
prevent unauthorized access by children. To avoid accidents, ensure that children
cannot use the spa or hot tub unless they are supervised at all times.
120 VOLT, CORD AND PLUG CONNECTED MODELS
4.
DANGER:
RISK OF INJURY. Connect only to a grounded source.
5. Do not bury the power cord.
6.
WARNING:
To reduce the risk of electric shock, replace a damaged cord immediately.
7. A ground terminal (pressure wire connector) is provided on the surface of the control
box inside the equipment compartment. This connector should be bonded with a
minimum No. 8 AWG (8.4mm
2
) solid copper wire between this unit and any metal
ladders, metal water pipes, metal enclosures of electrical equipment, conduit or metal
equipment within five feet (1.5m) of the spa. If the spa is located on a reinforced
concrete pad, the reinforced steel should also be bonded to the ground terminal.
8.
WARNING:
Your spa is equipped with a ground fault circuit interrupter (GFCI) on
the end of the power supply cord. Before each use of the spa, with the plug
connected to the power supply and the unit operating, press the test button. The
unit should stop operating and the GFCI power indicator will go out. Wait thirty
seconds and then reset the GFCI by pressing the Reset button. The GFCI power
indicator will turn on, restoring power to the spa. If the interrupter does not perform
in this manner, it is an indication of an electrical malfunction and the possibility of an
electric shock. Disconnect the plug from the receptacle until the fault has been
identified and corrected.
NOTE:
Failure to wait thirty seconds before resetting the GFCI may cause the spas
power indicator on the control panel to blink. If this occurs, repeat the GFCI test procedure.
240 VOLT, PERMANENTLY INSTALLED OR CONVERTED MODELS
9. A ground terminal is provided on the terminal block (TB-1, terminal 7) located inside
the control box. To reduce the risk of electric shock, connect this terminal to the
grounding terminal of your electrical service or supply panel with a continuous green,
insulated copper wire. The wire must be equivalent in size to the circuit conductors
supplying the equipment. In addition, a bonding terminal (pressure wire connector) is
provided on the outside of the control box for bonding to local ground points. To
reduce the risk of electric shock, this connector should be bonded with a No. 8 AWG
(8.42mm
2
) solid copper wire to any metal ladders, water pipes, or other metal within
five feet (1.5m) of the spa to comply with local requirements.
(CONTINUED)
