ENGLISH
17
Using the control
1.
Power switch (Power)
Activate the massage function by pressing the
power switch. The status lamp goes on. Press
the power switch again to switch off the
massage function.
The status lamp flashes while the massage
mechanism is returning to the lowest point and
then switches off.
2.
Neck massage (Neck)
Open the neck massage function. The height of
the cushion is set manually. You can choose
between 4 positions.
3. Massage
zones
Use the zone buttons to select massage of
different parts of the back.
The whole back (Full)
The massage mechanism works up and down
along the back.
The upper part of the back (Upper)
The massage mechanism works on the upper
part of the back.
The lower part of the back (Lower)
The massage mechanism works on the lower
part of the back.
4. Intensity
(Seat)
There are three settings: L (low), M (medium)
and H (high). The status lamp shows the
selected setting. Press the button again to make
a new selection.
5. Heating
(Heat)
Press the heat button for comfortable heat
during the massage. The corresponding status
lamp goes on. Switch off the heat by pressing
the button again. The status lamp goes off.
For safety reasons, it is not possible to activate
heat unless the massage function is activated.
Press the button for the required part of the back. The corresponding status lamp goes on.
Switch off the heat by pressing the button again. The status lamp goes off.
Adjusting the cushion height
Adjust the height of the cushion by pressing in the adjusting button and pulling the cushion up or down to
the required height.
The cushion will stop in the required position when you release the button.
Adjusting the cushion angle
The cushion tips forward to a maximum of 90 degrees. Press the cushion forwards to the required angle.
You can choose between 5 positions.
To reset the original angle of the cushion, press the cushion forwards and then back.
NOTE:
Pushing the cushion forwards and back may cause a creaking sound.
This is quite normal.
